How To Maintain The Chimney Crowns
The caps come in various designs and
styles, like ones that are aerodynamic to reduce any downdraft from the passing
winds and breezes. The cap also comes with many other features, including a
solid top.
But sometimes the fire you burn will
send creosote particles out and they have been known to accumulate within the
cap that could eventually block the proper flow of air needed.
When doing the chimney cap repair,
the main goal is to clean off the built up creosote that can be a huge issue
for most metal caps.
·
The first step is to put on some
shoes with rubber soles and some clothes that will fit loosely on you. Then you
will want to set up your ladder - preferably an extension ladder that will
extend to about three feet above the ease to allow a safer way to climb onto
the roof. Don't forget to bring a Phillips screwdriver and a wrench as these
tools are the most important for this job.
·
If you lift the Chimney Repairs off and it is attached to the flue,
you need to locate the screws and unscrew them using your screwdriver. Then you
can use the wrench to hold the nuts steady during this part, provided there are
nuts. This will allow you to be able to take the cap down to make any necessary
repairs in your garage.
·
One way to remove the built up
creosote is to use a chisel and a hammer as a way of scraping it from the cap's
sides. It's probably a good idea to wear protective gloves to keep your hands
protected from the creosote. When you have chipped all of it off, you can
collect what you have removed into a bag for disposal in the garbage can.
·
While you have it detached, you have
a chance to repair any joints that might have been separated. This can be done
by screwing them back together with the use of self-tapping sheet metal screws.
Afterwards, you can clamp that joint by using a C-clamp followed by using a
drill and a No. 2 drill bit to drive the screw. On a side note, there's no need
to create any predrilled holes since the self-tapping screws will do that for
you.
·
With the Chimney Inspections,
you can then go back up the ladder onto the roof to make any needed repairs to
the crown, which is the part that is the lining around the outside of the flue.
If you are looking for Chimney Crowns, then contact https://www.cochimney.com/
Comments
Post a Comment